BS EN 60444-1:1997
Current
The latest, up-to-date edition.
Measurement of quartz crystal unit parameters Basic method for the measurement of resonance frequency and resonance resistance of quartz crystal units by zero phase technique in a π-network
Hardcopy , PDF
English
08-15-2000
Committees responsible
National foreword
Foreword
1 Scope
2 Definition of resonance frequency
3 Reference plane and shielding box
4 Principle of measurement
5 Measuring circuit
5.1 The p-network
5.2 Accessories of the p-network
5.3 Associated equipment
6 Method of measurement
6.1 Initial calibration of the p-network
6.2 Frequency and resistance measurement
Appendix A - Additional information on accuracy
Annex B (normative) updating of some formulae of Appendix A
Figure 1
Figure 2
Figure 3 - Plot showing the phase change from the value at
25 O versus reference resistor values from 0 to
100 O AT 10 MHz, 50 MHz, 100 MHz and 200 MHz.
Measuring circuit according to, Figure 1 page 4
Figure 4 - Reference resistors and shorting blank
Figure 5a
Figure 5a
Figure A.1
Figure A.2
Figure A.3
Figure A.4
Figure A.5
Figure A.6
Figure A.7
Figure A.8 - A typical phase/frequency variation of an
adjusted p-network with a 25 O reference
resistor
Figure A.9 - Typical p-network
Figure A.10 - Detail of network assembly
Figure A.11 - Dimensions of contacting plates and earthed
shield; x indicates position of rod and disk
centers of p-network
Figure A.12 - Position of the reference resistor with
respect to the network contacting plates
Figure A.13 - Other design of a p-network
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.