BS EN 60793-2-10:2017

FOREWORD
1 Scope
2 Normative references
3 Terms, definitions
4 Abbreviated terms
5 Specifications
Annex A (normative) - Specifications for sub-category
        A1a multimode fibres
Annex B (normative) - Specifications for sub-category
        A1b multimode fibres
Annex C (normative) - Specifications for sub-category
        A1d multimode fibres
Annex D (normative) - Fibre differential mode delay
        (DMD), calculated effective modal bandwidth
        (EMB[c]) and calculated overfilled modal bandwidth
        (OMB[c]) requirements
Annex E (informative) System, modal bandwidth,
        and transmitter considerations
Annex F (informative) - Bandwidth nomenclature
        explanation
Annex G (informative) - Preliminary indications for
        items needing further study
Annex H (informative) - Applications and cabling
        categories supported by A1 fibres
Annex I (informative) - 1-Gigabit, 10-Gigabit,
        25-Gigabit, 40-Gigabit and 100-Gigabit Ethernet
        applications
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Pertains to optical fibre types A1a, A1b, and A1d, These fibres are used or can be incorporated in information transmission equipment and optical fibre cables.

This part of IEC60793 is applicable to optical fibre sub-categories A1a, A1b, and A1d. These fibres are used or can be incorporated in information transmission equipment and optical fibre cables. Sub-category A1a applies to 50/125µm graded index fibre. Four bandwidth grades are defined as models A1a.1, A1a.2, A1a.3 and A1a.4. Each of these bandwidth grades is defined for two levels of macrobend loss performance that are distinguished by \'a\' or \'b\' suffix. Those models with suffix \'a\' are specified to meet traditional macrobend loss performance levels. Those models with suffix \'b\' are specified to meet enhanced macrobend loss (i.e. lower loss) performance levels. Model A1a.4 supports single wavelength or multi-wavelength transmission systems in the vicinity of 850nm to 950nm. Sub-category A1b applies to 62,5/125µm graded index fibre and sub-category A1d applies to 100/140µm graded index fibre. Other applications include, but are not restricted to, the following: short reach, high bit-rate systems in telephony, distribution and local networks carrying data, voice and/or video services; on-premises intra-building and inter-building fibre installations including data centres, local area networks (LANs), storage area networks (SANs), private branch exchanges (PBXs), video, various multiplexing uses, outside telephone cable plant use, and miscellaneous related uses. Three types of requirements apply to these fibres: general requirements, as defined in IEC60793‑2 ; specific requirements common to the category A1 multimode fibres covered in this document and which are given in Clause5; particular requirements applicable to individual fibre sub-categories and models, or specific applications, which are defined in the normative specification annexes.