BS EN 60811-4-2:2004

1 General
   1.1 Scope
   1.2 Normative references
2 Terms and definitions
3 Test values
4 Applicability
5 Type tests and other tests
6 Pre-conditioning
7 Median value
8 Tensile strength and elongation at break after
   conditioning at elevated temperature
   8.1 General
   8.2 Conditioning procedure
   8.3 Tensile strength and elongation tests after
        conditioning at elevated temperature
   8.4 Expression of results
9 Wrapping test after conditioning at elevated
   temperature
   9.1 General
   9.2 Conditioning procedure
   9.3 Test procedure
   9.4 Evaluation of results
10 Wrapping test after thermal ageing in air
   10.1 General
   10.2 Apparatus
   10.3 Sampling
   10.4 Ageing procedure
   10.5 Test procedure
   10.6 Evaluation of results
11 Mass increase of insulation
   11.1 General
   11.2 Sampling
   11.3 Test procedure
   11.4 Calculation
Annex A (normative) Long-term stability test
Annex B (normative) Test method for copper-catalyzed
                     oxidative degradation of polyolefin
                     insulated conductors (Oxidation Induction
                     Time (OIT) test)
Annex ZA (normative) Normative references to international
                     publications with their corresponding
                     European publications
Bibliography

Describes the test methods for testing polymeric insulating and sheathing materials of electric and optical fibre cables for power distribution and communications, including cables used on ships and in offshore applications. These test methods apply specifically to polyolefin insulation and sheath. The principal changes with respect to the previous edition are listed below: a) A measurement of tensile strength is included in Clause 8. b) Clause 10 is now the only method in EN 60811 for wrapping test after thermal ageing in air. c) Two ageing conditions are now specified for the long-term stability test in Annex A.

Specifies the test methods for testing polymeric insulating and sheathing materials of electric and optical fibre cables for power distribution and communications, including cables used on ships and in offshore applications. These test methods apply specifically to polyolefin insulation and sheath. The principal changes with respect to the previous edition are listed below: a) A measurement of tensile strength is included in Clause 8. b) Clause 10 is now the only method in IEC 60811 for wrapping test after thermal ageing in air. c) Two ageing conditions are now specified for the long-term stability test in Annex A.