BS EN 60838-2-3:2017

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General conditions for tests
6 Classification
7 Marking
8 Protection against electric shock
9 Terminals
10 Provision for earthing
11 Construction
12 Moisture resistance, insulation resistance and electric
   strength
13 Mechanical strength
14 Screws, current-carrying parts and connections
15 Creepage distances and clearances
16 Endurance
17 Resistance to heat and fire
18 Resistance to excessive residual stresses (season cracking)
   and to rusting
Annex A (normative) - Lampholders covered by this standard
Annex B (normative) - Test probes for checking gasket sleeves
        on lampholders for higher IP protection
Annex C (informative) - Explanatory details for the installation
        of lampholders according to 11.1
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZZ (informative) - Relationship between this
         European standard and the safety objectives of
         Directive 2014/35/EU [2014 OJ L96] aimed to
         be covered

Pertains to lampholders for double-capped linear LED lamps intended for building-in (to be used for general lighting service and with caps as listed in Annex A).

This part of IEC60838‑2 applies to lampholders for double-capped linear LED lamps intended for building-in (to be used for general lighting service and with caps as listed in AnnexA). Lampholders within the scope of this standard do not include heat management. Double-capped linear LED lamps can also be used with lampholders originally been designated for other technologies. The requirementsfor these lampholders are covered by separate standards.