BS EN 61439-1:2011

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Interface characteristics
6 Information
7 Service conditions
8 Constructional requirements
9 Performance requirements
10 Design verification
11 Routine verification
Annex A (normative) - Minimum and maximum cross-section
        of copper conductors suitable for connection
        to terminals for external conductors
Annex B (normative) - Method of calculating the
        cross-sectional area of protective
        conductors with regard to thermal stresses
        due to currents of short duration
Annex C (informative) - User information template
Annex D (informative) - Design verification
Annex E (informative) - Rated diversity factor
Annex F (normative) - Measurement of clearances and creepage
Annex G (normative) - Correlation between the nominal voltage
        of the supply system and the rated impulse withstand
        voltage of the equipment
Annex H (informative) - Operating current and power loss of
        copper conductors
Annex I (Void)
Annex J (normative) - Electromagnetic compatibility (EMC)
Annex K (normative) - Protection by electrical separation
Annex L (informative) - Clearances and creepage distances
        for North American region
Annex M (informative) - North American temperature rise
        limits
Annex N (normative) - Operating current and power loss
        of bare copper bars
Annex O (informative) - Guidance on temperature rise
        verification
Annex P (normative) - Verification of the short-circuit
        withstand strength of busbar structures by comparison
        with a tested reference design by calculation
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications
Annex ZZ (informative) - Coverage of Essential Requirements
         of EC Directive 2004/108/EC

Specifies the definitions and states the service conditions, construction requirements, technical characteristics and verification requirements for low-voltage switchgear and controlgear assemblies.

IEC 61439-1:2011 lays down the definitions and states the service conditions, construction requirements, technical characteristics and verification requirements for low-voltage switchgear and controlgear assemblies. This standard cannot be used alone to specify an ASSEMBLY or used for a purpose of determining conformity. ASSEMBLIES shall comply with the relevant part of the IEC 61439 series; Parts 2 onwards. This standard applies to low-voltage switchgear and controlgear assemblies (ASSEMBLIES) only when required by the relevant ASSEMBLY standard as follows:
- ASSEMBLIES for which the rated voltage does not exceed 1 000 V in case of a.c. or 1 500 V in case of d.c.;
- stationary or movable ASSEMBLIES with or without enclosure;
- ASSEMBLIES intended for use in connection with the generation, transmission, distribution and conversion of electric energy, and for the control of electric energy consuming equipment;
- ASSEMBLIES designed for use under special service conditions, for example in ships and in rail vehicles provided that the other relevant specific requirements are complied with;
- ASSEMBLIES designed for electrical equipment of machines provided that the other relevant specific requirements are complied with. This second edition cancels and replaces the first edition published in 2009. It constitutes a technical revision. This second edition includes the following significant technical changes with respect to the last edition of IEC 61439-1:
- revision of service conditions in Clause 7;
- numerous changes regarding verification methods in Clause 10;
- modification of routine verification in respect of clearances and creepage distances (see 11.3);
- adaption of the tables in Annex C and Annex D to the revised requirements and verification methods;
- revision of the EMC requirements in Annex J;
- shifting of tables from Annex H to new Annex N;
- new Annex O with guidance on temperature rise verification;
- new Annex P with a verification method for short-circuit withstand strength (integration of the content of IEC/TR 61117);
- update of normative references;
- general editorial review.