BS EN 62034:2012

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Test duration and interval
6 Protection of a building during the periods
  of test and subsequent recharge of the
  emergency lighting system
7 Indication and recording of results of tests
  that the equipment has to perform
Annex A (informative) - Examples of typical
        automatic test systems
Annex B (normative) - Classification of ATS types
Annex C (informative) - Example of guidance for
        the use of ATS systems
Bibliography
Annex ZA (normative) - Normative references
         to international publications with their
         corresponding European publications

Describes the basic performance and safety requirements for individual products and components that are incorporated into automatic test systems for use with emergency lighting systems on supply voltages not exceeding 1000 V.

IEC 62034:2012 specifies the basic performance and safety requirements for individual products and components that are incorporated into automatic test systems for use with emergency lighting systems on supply voltages not exceeding 1 000 V. This second edition cancels and replaces the first edition published in 2006. It constitutes a technical revision. The main changes with respect to the first edition are the improvement of the understanding of the requirements in the various clauses and the compliance requirements listed below and the updating of the normative references.
- 4.2 Monitoring of the timing circuit
- 4.3 Functional requirements
- 4.3.1 The automatic test system (ATS)
- 4.4.2 Intercommunications failure
- 4.4.4 Component failures
- 4.4.7 Software failure
- 5.1 Functional test
- 5.2 Duration test
- 6.2.2 Timing accuracy
- 6.3.2.2 Testing alternate luminaires
- 6.3.3.4 Limited duration test
- 7.1 General.