BS EN 62301:2005

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General conditions for measurements
  4.1 General
  4.2 Test room
  4.3 Power supply
  4.4 Supply voltage waveform
  4.5 Power measurement accuracy
5 Measurements
  5.1 General
  5.2 Selection and preparation of appliance
      or equipment
  5.3 Procedure
6 Test report
  6.1 Appliance (equipment) details
  6.2 Test parameters
  6.3 Measured data, for each mode as applicable
  6.4 Test and laboratory details
Z1 Tolerances and control procedures
   Z1.1 For power consumption greater than 1 W
   Z1.2 For power consumption less or equal to 1 W
Annex A (informative) Some typical modes for
         selected appliance types
Annex B (informative) Notes on the measurement of
         low power modes
Annex C (informative) Converting power values to
         energy
Annex D (informative) Determination of uncertainty
         of measurement
Annex ZA (normative) Normative references to
         international publications with their
         corresponding European publications
Bibliography

Describes the methods of measurement of electrical power consumption in standby mode.

Specifies methods of measurement of electrical power consumption in standby mode. It is applicable to mains powered electrical household appliances and to the mains powered parts of appliances that use other fuels such as gas or oil. This standard does not specify safety requirements. It does not specify minimum performance requirements nor does it set maximum limits on power or energy consumption.