BS EN 755-8:2016

European foreword
1 Scope
2 Normative references
3 Tolerances on dimensions
4 Tolerances on form
Annex A (informative) - Wall thickness variation (eccentricity)
Bibliography

Defines the tolerances on dimensions and form for aluminium and aluminium alloy extruded porthole tubes with an outside diameter (OD) from 8 mm to 450 mm or with a cross section contained within a circumscribing circle (CD) from 10 mm to 350 mm, supplied in straight lengths.

This European Standard specifies the tolerances on dimensions and form for aluminium and aluminium alloy extruded porthole tubes with an outside diameter ( OD) from 8mm to 450mm (round tube, see Figure1) or with a cross section contained within a circumscribing circle ( CD) from 10mm to 350mm (other than round tube, see Figure2), supplied in straight lengths. This European Standard only applies to extruded porthole tube for general engineering applications made in the following alloys: ENAW‑1050A , ENAW‑1200 , ENAW‑1350 ; ENAW‑3003 , ENAW‑3103 ; ENAW‑5005 , ENAW‑5005A , ENAW‑5049 , ENAW‑5051A , ENAW‑5251 , ENAW‑5052 ; ENAW‑6101A , ENAW‑6101B , ENAW‑6005 , ENAW‑6005A , ENAW‑6008 , ENAW‑6110A , ENAW‑6012 , ENAW‑6014 , ENAW‑6018 , ENAW‑6351 , ENAW‑6060 , ENAW‑6360 , ENAW‑6061 , ENAW‑6261 , ENAW‑6262 , ENAW‑6262A , ENAW‑6063 , ENAW‑6063A , ENAW‑6463 , ENAW‑6065 , ENAW‑6081 , ENAW‑6082 ; ENAW‑6182 ; ENAW‑7003 , ENAW‑7005 , ENAW‑7108 , ENAW‑7108A , ENAW‑7020 . The temper designations used in this part are according to EN515 . This European Standard only applies to tube produced by the tube porthole/bridge method. This European Standard does not apply to: extruded tubes produced by the seamless, die/mandrel method ( EN755‑7 ), tubes delivered in coils ( EN13957 ), coiled tubes cut to length ( EN13957 ). [Image removed.] [Image removed.]