BS EN ISO 10360-2:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Environmental and metrological requirements
6 Acceptance tests and reverification tests
7 Compliance with specifications
8 Applications
9 Indication in product documentation and data sheets
Annex A (informative) - Interim check
Annex B (normative) - Artefacts that represent a calibrated
                      test length
Annex C (informative) - Alignment of gauges
Annex D (normative) - Mathematical adjustments to low CTE
                      artefacts
Annex E (informative) - Location of the single stylus
                        probing test
Annex F (informative) - Relation to the GPS matrix model
Bibliography

Describes the acceptance tests for verifying the performance of a coordinate measuring machine (CMM) used for measuring linear dimensions as stated by the manufacturer.

This part of ISO10360 specifies the acceptance tests for verifying the performance of a coordinate measuring machine (CMM) used for measuring linear dimensions as stated by the manufacturer. It also specifies the reverification tests that enable the user to periodically reverify the performance of the CMM.

The acceptance and reverification tests given in this part of ISO10360 are applicable only to Cartesian CMMs using contacting probing systems of any type operating in the discrete-point probing mode.

This part of ISO10360 does not explicitly apply to:

• non-Cartesian CMMs; however, parties may apply this part of ISO10360 to non-Cartesian CMMs by mutual agreement;

• CMMs using optical probing; however, parties may apply this approach to optical CMMs by mutual agreement.

This part of ISO10360 specifies performance requirements that can be assigned by the manufacturer or the user of a CMM, the manner of execution of the acceptance and reverification tests to demonstrate the stated requirements, rules for proving conformance, and applications for which the acceptance and reverification tests can be used.