BS EN ISO 10360-4:2001

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements for metrological characteristics
  4.1 Error of indication
  4.2 Time for scanning test
  4.3 Environmental conditions
  4.4 Stylus system
  4.5 Operating conditions
5 Acceptance test and reverification test
  5.1 General
  5.2 Principles
  5.3 Measuring equipment
  5.4 Procedure
  5.5 Obtention of test results
6 Compliance with specifications
  6.1 Acceptance test
  6.2 Reverification test
7 Applications
  7.1 Acceptance test
  7.2 Reverification test
  7.3 Interim check
Annex A (informative) Interim check
Annex B (informative) Workpiece related influences
Annex C (informative) Relation to the GPS matrix model
Bibliography

Specifies the acceptance test which verifies that the performance of a CMM used in scanning measuring mode is as stated by the manufacturer.