BS EN ISO 14310:2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviated terms
5 Functional specification
   5.1 General
   5.2 Functional characteristics
   5.3 Well parameters
   5.4 Operational parameters
   5.5 Environmental compatibility
   5.6 Well equipment compatibility
   5.7 Quality control
   5.8 Design validation
6 Technical specification
   6.1 General
   6.2 Technical characteristics
   6.3 Design criteria
   6.4 Design verification
   6.5 Design validation
   6.6 Design changes
   6.7 Functional test parameters
   6.8 Other validations
7 Supplier/manufacturer requirements
   7.1 Data control
   7.2 Documentation requirements
   7.3 Product identification
   7.4 Quality control
   7.5 Functional test
8 Repair
Annex A (normative) Special validation grade with acceptance
        criterion of zero bubbles (V0)
Bibliography

Provides requirements for packers and bridge plugs for use in the petroleum and natural gas industry. Applicable to those products meeting the definition of a packer or bridge plug intended for petroleum and natural gas industry subsurface operations. Applicable only to product applications within a conduit.

This International Standard provides requirements and guidelines for packers and bridge plugs as defined herein for use in the petroleum and natural gas industry. This International Standard provides requirements for the functional specification and technical specification, including design, design verification and validation, materials, documentation and data control, repair, shipment, and storage. In addition, products covered by this International Standard apply only to applications within a conduit. Installation and maintenance of these products are outside the scope of this International Standard.