BS EN ISO 2063-2:2017

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements for the manufacturer
5 Quality assurance measures for the manufacturer
6 Manufacturing of thermal-sprayed coatings
7 Tests - Test procedures
8 Health and safety and environment protection
9 Additional requirements for working on-site
10 Execution of spray works on-site in the case of planned
   maintenance of a service operated coating
11 Tests - Test procedures
12 Documentation of the procedure and tests in the case
   of maintenance
13 Health and safety and environment protection on-site
Annex A (normative) - Adhesion testing using the pull-off test
        in accordance with ISO 4624
Annex B (informative) - Documentation of the applied
        maintenance procedure, the thermal spray procedure
        and test results in the case of a planned maintenance
Annex C (informative) - Documentation of the applied
        thermal spray procedure and test results in the case
        of a new manufacturing
Annex D (informative) - Test certificate for job reference
        qualification for thermal sprayers working on-site in
        accordance with ISO 2063-2
Annex E (informative) - Test specimens - Spray positions
Annex F (informative) - Assessment of the coatability
Annex G (informative) - Bend test and its execution
Annex H (informative) - Additional information for surface
        preparation
Annex I (informative) - Further details for sealing
Annex J (informative) - Further instructions for safety and
        activities on-site
Annex K (informative) - Repair procedures of service loaded
        coatings and recommended repair procedures
Bibliography

Gives requirements for corrosion protection of steel structures, components or parts, which are coated by thermal spraying of zinc, aluminium or their alloys.

This document specifies requirements for corrosion protection of steel structures, components or parts, which are coated by thermal spraying of zinc, aluminium or their alloys.

This document specifies requirements for coating manufacturers of surface preparation, thermal spraying, testing and post treatments, e.g. sealing of the coating. This document applies to metallic corrosion protection coatings in the case of new fabrication in the workshop, as well as on-site and for repair on-site after assembly.

Requirements for coating thickness, minimum adhesive strength and surface conditions, specified in a coating specification, are given.

Recommendations are given for suitable process steps and quality assurance measures for new production and maintenance and for supervising of corrosion protection works.

This document covers the application of thermal-sprayed zinc, aluminium and their alloys for protection against corrosion in the temperature range between –50°C to +200°C. Heat-resistant protective coatings of aluminium are covered by ISO17834 and are not in the scope of this document.

This document specifies requirements for the equipment, the working place and the qualification of the spray and testing personnel.

NOTE ISO2063‑1:2017 is addressed to the designer and to the planning engineer of corrosion protection system.