BS EN ISO 7787-4:2002

Foreword
Introduction
1 Scope
2 Normative references
3 Symbols
4 Requirements
   4.1 Materials
   4.2 Shapes
   4.3 Dimensions and number of blades
   4.4 Toothing
   4.5 Run-out
5 Test procedure
   5.1 Shapes
   5.2 Dimensions and number of blades
   5.3 Toothing
   5.4 Run-out
6 Acceptance quality limit (AQL)
7 Designation of toothing and number of blades
8 Marking
9 Labelling on the package
10 Packaging

Specifies the shape and dimensional characteristics, number of blades, type of toothing and run-out for the ten most common miniature carbide laboratory cutters, which are predominantly used in the dental laboratory.

This part of ISO7787 specifies the shape and dimensional characteristics, number of blades, type of toothing and run-out for the ten most common miniature carbide laboratory cutters, which are predominantly used in the dental laboratory.