BS IEC 60079-19:1993

INTRODUCTION
1 Scope
2 General requirements
    2.1 Normative references
    2.2 Definitions and terms
    2.3 Statutory requirements
    2.4 Instructions for the manufacturer
    2.5 Instructions for the user
    2.6 Instructions for the repairer
3 Additional requirements for the repair and overhaul
    of an apparatus with type of protection "d"
    (flameproof)
    3.1 Application
    3.2 Repair and overhaul
    3.3 Reclamation
    3.4 Modifications
4 Additional requirements for the repair and overhaul of
    an apparatus with type of protection "i" (flameproof)
    4.1 Application
    4.2 Repair and overhaul
    4.3 Reclamation
    4.4 Modifications
5 Additional requirements for the repair and overhaul of
    an apparatus with type of protection "p" (pressurized)
    5.1 Application
    5.2 Repair and overhaul
    5.3 Reclamation
    5.4 Modifications
6 Additional requirements for the repair and overhaul of
    an apparatus with type of protection "e" (increased
    safety)
    6.1 Application
    6.2 Repair and overhaul
    6.3 Reclamation
    6.4 Modifications
7 Additional requirements for the repair and overhaul of
    an apparatus with type of protection "n" (non-sparking)
    7.1 Application
    7.2 Repair and overhaul
    7.3 Reclamation
    7.4 Modifications
Annex A - Identification of repaired apparatus by marking

Provides instructions, mainly technical, on the repair, overhaul, reclamation and modification of a certified apparatus to be used in explosive atmospheres (not including mining applications or explosive processing and manufacture). Does not apply to maintenance nor advise on cable entry systems requiring renewal when the apparatus is re-installed, and assumes that good engineering practices are used.