BS ISO 23529:2016

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Identification and record keeping
5 Standard laboratory conditions
6 Storage of samples and test pieces
7 Preparation of test pieces
8 Conditioning
9 Measurement of the dimensions of test pieces
10 Conditions of test
11 Test chambers
12 Test report
Annex A (normative) - Conditioning times for
        rubber test pieces
Bibliography

Describes general procedures for the preparation, measurement, marking, storage, and conditioning of rubber test pieces for use in physical tests specified in other International Standards, and the preferred conditions to be used during the tests.

This document specifies general procedures for the preparation, measurement, marking, storage, and conditioning of rubber test pieces for use in physical tests specified in other International Standards, and the preferred conditions to be used during the tests. Special conditions, applicable to a particular test or material or simulating a particular climatic environment, are not included, nor are special requirements for testing whole products.

This document also specifies the requirements for the time interval to be observed between forming and testing of rubber test pieces and products. Such requirements are necessary to obtain reproducible test results and to minimize disagreements between customer and supplier.