BS ISO 6194-1:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Seal types and examples
   5.1 Seal outside-diameter construction
   5.2 Sealing lip arrangements
6 Pressure and nominal dimensions
   6.1 Pressure
   6.2 Nominal dimensions
7 Shafts
   7.1 Shaft ends
   7.2 Diametral tolerance
   7.3 Surface roughness and hardness
8 Housings
   8.1 Dimensions
   8.2 Housing-bore tolerance
   8.3 Housing-bore surface roughness
9 Seal tolerances
   9.1 Seal width
   9.2 Seal outside diameter
10 Size identification code
11 Identification statement
Annex A (informative) - Seal specification
Bibliography

Describes seals utilising elastomeric sealing elements.

This part of ISO6194 describes seals utilising elastomeric sealing elements. They are considered suitable for use under low-pressure conditions (see 6.1).

This part of ISO6194 shows seal types and examples. It also specifies the nominal dimensions and tolerances of the seals, shafts and housings, as well as a dimensional identification code.

NOTE ISO6194 is complementary to ISO16589 which covers seals incorporating thermoplastic sealing elements.