CEI EN 61347-2-13 : 2015

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for protective earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings of ballasts
14 Fault conditions
16 Construction
17 Creepage distances and clearances
18 Screws, current-carrying parts and connections
19 Resistance to heat, fire and tracking
20 Resistance to corrosion
Annex A (normative) - Test to establish whether a
        conductive part is a live part which may cause
        an electric shock
Annex B (normative) - Particular requirements for
        thermally protected lamp controlgear
Annex C (normative) - Particular requirements for
        electronic lamp controlgear with means of
        protection against overheating
Annex D (normative) - Requirements for carrying
        out the heating tests of thermally protected
        lamp controlgear
Annex E (normative) - Use of constant S other
        than 4 500 in t[w] tests
Annex F (normative) - Draught-proof enclosure
Annex G (normative) - Explanation of the derivation
        of the values of pulse voltages
Annex H (normative) - Tests
Annex I (normative) - Particular additional requirements
        for SELV d.c. or a.c. supplied electronic controlgear
        for LED modules
Annex J (normative) - Particular additional safety
        requirements for a.c., a.c./d.c. or d.c. supplied
        electronic controlgear for emergency lighting
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Describes the electronic controlgear for use on d.c. or a.c. supplies up to 1000 V (a.c. at 50 Hz or 60 Hz) and at an output frequency which can deviate from the supply frequency, associated with LED modules.