DD IEC PAS 61076-2-107 : DRAFT 2007

1 General information
  1.1 Scope
  1.2 Recommended method of termination
  1.3 Ratings and characteristics
      1.3.1 Electrical contacts
      1.3.2 Optic contacts
  1.4 Normative references
  1.5 Marking
  1.6 Safety aspects
2 Technical information
  2.1 Terms and definitions
      2.1.1 Mounting orientation
  2.2 Survey of styles and variants
      2.2.1 Fixed connectors
      2.2.2 Free connectors
      2.2.3 Adaptor
3 Dimensions
  3.1 General
  3.2 Interface dimensions
      3.2.1 Pin front view plug connector
  3.3 Engagement (mating) information
  3.4 Gauges for electric contacts
4 Characteristics
  4.1 Climatic category
  4.2 Electrical characteristics (only electrical contacts)
      4.2.1 Rated voltage - Impulse voltage - Pollution degree
      4.2.2 Voltage proof
      4.2.3 Current-carrying capacity
      4.2.4 Contact resistance
      4.2.5 Insulation resistance
  4.3 Optic characteristics (only optic contacts)
  4.4 Mechanical
      4.4.1 IP degree of protection
      4.4.2 Mechanical operation
      4.4.3 Insertion and withdrawal forces
      4.4.4 Contact retention in insert
      4.4.5 Polarizing method
      4.4.6 Vibration (sinusoidal)
5 Test schedule
  5.1 General
      5.1.1 Arrangement for contact resistance measurements
      5.1.2 Arrangement for dynamic stress tests (vibration)
  5.2 Test schedule
      5.2.1 Test group P - Preliminary
      5.2.2 Test group AP - Dynamic/Climatic
      5.2.3 Test group BP - Mechanical endurance
      5.2.4 Test group CP - Electrical load
      5.2.5 Test group DP - Chemical resistivity
      5.2.6 Test group EP - Connection method tests
BIBLIOGRAPHY

Specifies circular M12-connectors typically used for industrial process measurement and control.