DEFSTAN 03-21/5(2011) : 2011
Withdrawn
MECHANICAL METHODS FOR THE INDUCEMENT OF RESIDUAL SURFACE COMPRESSIVE STRESSES
English
01-01-2011
09-25-2016
Foreword
0 Introduction
1 Scope
2 Warning
3 Normative References
4 Definitions
5 Information to be Supplied to the Processor
6 Process Control Schedule
7 Process Requirements - Limitations on Use
8 Process Requirements - Preparation Prior to Treatment
9 Process Requirements - Treatment Techniques
10 Process Requirements - Quality Control
11 Process Requirements - Post Treatment Operations
12 Process Requirements - Records
13 Treatment Techniques - Mechanised Shot Peening
14 Manual Shot Peening
15 Needle Peening
16 Flail Peening
17 Hammer Peening
18 Roller Burnishing
Annex A - Determination of the Intensity of Shot Peening
Annex B - Saturation
Annex C - Test for Freedom from Iron Residue
Specifies the requirements to be observed when the controlled mechanical working of metal surfaces is carried out in order to induce surface compressive stresses.
| DevelopmentNote |
Supersedes DEFSTAN 03-21/4(2008). (10/2011) This standard is obsolescent because it is no longer required for procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (09/2016)
|
| DocumentType |
Standard
|
| Pages |
38
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Withdrawn
|
| Supersedes |
| SAE AMS03_4A | The Pre-Treatment and Protection of Steel Items of Specified Maximum Tensile Strength Exceeding 1450 MPa |
| SAE AMS03_19A | Electro-Deposition of Cadmium |
| SAE AMS03_27A | Electro-Deposition of Nickel for Engineering Purposes |
| SAE AMS03_20A | Electro-Deposition of Zinc |
| SAE AMS03_25A | Sulfuric Acid Anodizing of Aluminum and Aluminum Alloys |
| SAE AMS 03-28-2 : 2017 | PHYSICAL VAPOR DEPOSITION OF METALS: PHYSICAL VAPOR DEPOSITION OF CADMIUM FOR PROTECTION AGAINST CORROSION |
| SAE AMS03_14A | Electrodeposition of Chromium for Engineering Purposes |
| ISO 565:1990 | Test sieves — Metal wire cloth, perforated metal plate and electroformed sheet — Nominal sizes of openings |
| BS 410-1:2000 | Test sieves. Technical requirements and testing Test sieves of metal wire cloth |
| ISO/TS 21432:2005 | Non-destructive testing — Standard test method for determining residual stresses by neutron diffraction |
| DEFSTAN 03-2/6(2011) : 2011 | CLEANING AND PREPARATION OF METAL SURFACES |
| BS EN 15305:2008 | Non-destructive testing. Test method for residual stress analysis by X-ray diffraction |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.