DEFSTAN 05-61(PT12)/1(1987) : 1987
Withdrawn
QUALITY ASSURANCE PROCEDURAL REQUIREMENTS - PART 12: CONTROL OF WALL THICKNESS IN DESIGN AND MANUFACTURE OF FLYING CONTROL SYSTEMS
English
01-01-1987
11-02-2015
Preface
0 Introduction
1 Scope
2 Health and Safety Warning
3 Definitions
4 Requirements
5 Verification Methods
6 Implementation by the Manufacturing Contractor
Describes quality/inspection control of wall thickness of bored, counterbored, drilled or other hollow parts in flying control systems
| DevelopmentNote |
Supersedes QTR 1/AQD & QTM 15 (07/2003) This standard is obsolescent because it is no longer required for the procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (09/2007)
|
| DocumentType |
Standard
|
| Pages |
2
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Withdrawn
|
| DEFSTAN 00-970(PT7)SEC7/1(2006) : 2006 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 7: ROTORCRAFT - SECTION 7: INSTALLATIONS |
| DEFSTAN 00-970(PT7)SEC2/SUPP4/5(2015) : INTERIM | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 7: ROTORCRAFT - SUPPLEMENT 4: DESIGN AND CONSTRUCTION (SUBPART D) |
| DEFSTAN 00-970(PT7)SEC2/SUPP4/6(2015) : 2015 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 7: ROTORCRAFT - SUPPLEMENT 4: DESIGN AND CONSTRUCTION (SUBPART D) |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.