DEFSTAN 93-68/2(2009) : 2009
Withdrawn
POLYTETRAFLUOROETHYLENE (PTFE), ETCHED (SHEET, TAPE AND COMPONENTS)
English
01-01-2009
08-02-2012
Foreword
0 Introduction
1 Scope
2 Warning
3 Normative References
4 Abbreviations
5 Information To Be Supplied By The Purchaser
6 Material
7 Product Conformity Certification (PCC)
8 Test Requirements
9 Keeping Quality
10 Containers and Marking of Containers
Annex A - Method of Test for the Determination of Adhesive
Strength
Describes requirements for sintered polytetrafluoroethylene (PTFE) sheet, tape, and moulded or machined components, suitably etched to permit adhesive bonding.
| DevelopmentNote |
Supersedes DEFSTAN 93-68/1(1995). (03/2010)
|
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Withdrawn
|
| Supersedes |
| BS ISO 5893:2002 | Rubber and plastics test equipment. Tensile, flexural and compression types (constant rate of traverse). Specification |
| BS EN ISO 13000-1:2005 | Plastics. Polytetrafluoroethylene (PTFE) semi-finished products Requirements and designation |
| BS 5350-A1:1976 | Methods of test for adhesives. Adherends Adherend preparation |
| BS EN ISO/IEC 17050-1:2010 | Conformity assessment. Suppliers declaration of conformity General requirements |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.