DEFSTAN 95-32/2(2004) : 2004
Withdrawn
ALUMINIUM ALLOY ARMOUR EXTRUSIONS AND FORGINGS (7019)
01-12-2013
03-30-2011
Preface
Main Text
SECTION 1GENERAL REQUIREMENTS
0 Introduction
1 Scope
2 WARNING
3 Related Documents
4 Definitions
5 General
6 Basis of Specification
7 Precautionary Note on Stress Corrosion Cracking
8 Precautionary Note on Bending
SECTION 2 MATERIAL VALIDATION
9 Material Requirements
10 Documentation
SECTION 3 PRODUCTION REQUIREMENTS
11 Production Requirement for Extrusions and Forgings
ANNEX A Ballistic Assessment
ANNEX B Mechanical Properties
ANNEX C Chemical Composition
ANNEX D Weldability
ANNEX E Short Transverse Stress Corrosion Testing
ANNEX F Grain Flow and Microstructure
ANNEX G Dimensional Tolerances
ANNEX H Workmanship
ANNEX I Identification
ANNEX J Bending
Defines the material and performance requirements for a weldable aluminium alloy armour in the form of extrusions and forgings, 6 mm and above, of nominal 4% Zinc 2% Magnesium Aluminium alloy in the solution treated and aged condition for the protection of crew and mechanism of armoured fighting vehicles against attack.
| DevelopmentNote |
Supersedes DEFSTAN 95-32/1(2002). (10/2004)
|
| DocumentType |
Standard
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Withdrawn
|
| Supersedes |
| BS 4L 100:1993 | Procedure for inspection, testing and acceptance of wrought aluminium and aluminium alloys |
| DEFSTAN 95-19/3(2004) : 2004 | ARMOUR HOMOGENEOUS ALUMINIUM ALLOY, HEAT TREATABLE, EXTRUSIONS AND FORGINGS (6 MM THICK AND OVER) |
| DEFSTAN 08-42/1(2000) : 2000 | ARMOUR PROOF, BALLISTIC TEST METHODOLOGY |
| ASTM G 85 : 2011 : REDLINE | Standard Practice for Modified Salt Spray (Fog) Testing |
| DEFSTAN 08-39/1(1998) : 1998 | CUTTING, WELDING AND CORROSION PROTECTION OF ALUMINIUM ALLOY MILITARY EQUIPMENT |
| DEFSTAN 08-202/1(2002) : 2002 | BALLISTIC TABLES FOR DEFENCE STANDARD 95-31 |
| DEFSTAN 95-31/2(2004) : 2004 | ALUMINIUM ALLOY ARMOUR PLATE (7019) |
| DEFSTAN 95-22/4(2004) : 2004 | ALUMINIUM ALLOY ARMOUR PLATE (HEAT TREATABLE 6-120 MM) |
| BS EN 755-1:2016 | Aluminium and aluminium alloys. Extruded rod/bar, tube and profiles Technical conditions for inspection and delivery |
| LN 65666:1974-07 | Stress-corrosion cracking test of wrought aluminium alloys for aircraft |
| BS EN 10002-1:2001 | Tensile testing of metallic materials Method of test at ambient temperature |