DIN 7157:1966-01
Withdrawn
RECOMMENDED SELECTION OF FITS; TOLERANCE ZONES; ALLOWANCES, FIT TOLERANCES
Hardcopy , PDF
English
01-01-1966
06-01-2014
The ISO Recommendations ISO/R 286 - 1962 contains a large number of tolerance zones in common use. These tolerance zones were taken over, with certain curtailments and additions, into DIN 7160, ISO allowances for external dimensions (shafts) for nominal sizes from 1 to 500 mm and into DIN 7161, ISO allowances for internal dimensions (holes) for nominal sizes from 1 to 500 mm. The unlimited combining of these tolerances zones would give rise to a very large number of fits. Economic manufacture, however, demands drastic limitation of the number of tolerance zones the combinations of which lead to universally applicable and recommended fits.
| DocumentType |
Standard
|
| Pages |
6
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Withdrawn
|
| DIN 7155-2:1966-08 | ISO-FITS FOR THE SHAFT BASIS SYSTEM; TOLERANCES OF FIT (CLEARANCES AND INTERFERENCES) |
| DIN 7155-1:1966-08 | ISO-FITS FOR THE SHAFT BASIS SYSTEM; TOLERANCE ZONES, DEVIATIONS |
| DIN 7154-1:1966-08 | ISO-FITS FOR THE HOLE BASIS SYSTEM; TOLERANCE ZONES, DEVIATIONS |
| DIN 7154-2:1966-08 | ISO-FITS FOR THE HOLE BASIC SYSTEM; TOLERANCES OF FIT (CLEARANCES AND INTERFERENCES) |