DIN EN 10259:1997-07

Foreword
1 Scope
2 Normative references
3 Definitions
4 Designation
5 Condition of delivery
6 Preferred thickness and tolerances on thickness
7 Tolerances on width
8 Preferred coil inner diameters
9 Tolerances on length
10 Flatness and edge waviness tolerances
11 Tolerances on out-of-squareness
12 Tolerances on edge camber
13 Ordered format (for sheet/plate)
14 Measurement
Annex A (informative) Bibliography

This standard is included in DIN Handbook 28 E. Applies to cold-rolled stainless, heat resisting and creep resisting steel flat products in thickness up to 6,5 mm, and rolled widths of 600 mm up to 2100 mm, delivered as: - wide strip (coils with a rolled width >= 600 mm), - sheet or plate cut from wide strip, - slit cold-rolled wide strip, - cut lengths obtained from slit cold-rolled wide strip or sheet.