DIN EN 13566-2:2006-02

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions, symbols and
  abbreviations
  3.1 Terms and definitions
  3.2 Symbols and abbreviations
4 Pipes at the 'M' stage
  4.1 Materials
  4.2 General characteristics
  4.3 Material characteristics
  4.4 Geometrical characteristics
  4.5 Mechanical characteristics
  4.6 Physical characteristics
  4.7 Jointing
  4.8 Marking
5 Fittings at the 'M' stage
  5.1 Requirement for fittings
  5.2 Marking
6 Ancillary components
7 Fitness for purpose of the system for pipes and
  fittings at the 'I' stage
8 Installation practice
  8.1 Preparatory work
  8.2 Storage, handling and transport
  8.3 Equipment
  8.4 Installation
  8.5 Process-related inspection and testing
  8.6 Lining termination
  8.7 Reconnecting to existing manholes and laterals
  8.8 Final inspection and testing
Annex A (informative) Recommended scheme for assessment
                      of conformity
Annex B (normative) Structured-wall pipes used for
                      continuous pipe lining - Specification
                      of layers
Annex C (normative) Structured-wall pipes used for continuous
                      pipe lining - Determination of residual
                      elongation and leaktightness following
                      application and removal of a specified
                      longitudinal pulling force
Annex D (normative) Structured-wall pipes used for continuous
                      pipe lining - Determination of resistance
                      to application of a specified temporary
                      longitudinal bending radius
Bibliography

This standard is included in DIN Handbook 152 and 13-4. Defines requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of non-pressure drainage and sewerage networks.