EN 10002-5:1991

1 Scope
2 Normative references
3 Principle
4 Definitions
5 Symbols and Designations
6 Test Pieces
7 Determination of original cross-sectional area (S[O])
8 Marking the original gauge length (L[O])
9 Testing apparatus
10 Conditions of testing
11 Determination of percentage elongation after fracture (A)
12 Determination of proof Strength (non-proportional extension)
   (R[p])
13 Determination of proof strength (total extension) (R[t])
14 Method of verification of permanent set strength (R[r])
15 Test report
Annex A (Normative annex) - Types of test piece to be used
        for thin products: sheets, strips and flats between
        0.1 mm AND 3 mm
Annex B (Normative annex) - Types of test pieces to be used
        in the case of wire, bars and sections with a diameter
        or thickness of less than 4 mm
Annex C (Normative annex) - Types of test pieces to be used
        in the case of sheets and flats of thickness equal
        to or greater than 3 mm, and wire, bars and sections
        of diameter or thickness equal to or greater than 4 mm
Annex D (Normative annex) - Types of test pieces to be used
        in the case of tubes
Annex E (Normative annex) - Measurement or percentage elongation
        after fracture, based on sub-division of the original
        gauge length
Annex F (Informative annex) - List of national standards
        corresponding to reference Euronorm 18
Annex G (Informative annex) - Bibliography

This European Standard specifies the method for tensile testing of metallic materials and defines the mechanical properties which can be determined thereby at elevated temperature. For certain particular metallic materials and applications, the tensile test may be subject of specific standards or particular requirements.