EN 10028-3:2017

European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Tolerances on dimensions
5 Calculation of mass
6 Classification and designation
7 Information to be supplied by the purchaser
8 Requirements
9 Inspection
10 Sampling
11 Test methods
12 Marking
Annex A (normative) - Evaluation of resistance
        to hydrogen induced cracking
Annex B (informative) - Information on welding
Annex C (informative) - Changes to the previous
        version EN 10028-3:2009
Annex ZA (informative) - Relationship between
         this European Standard and the Essential
         Requirements of Directive 2014/68/EU
         aimed to be covered
Bibliography

This European Standard specifies requirements for flat products for pressure equipment made of weldable fine grain steels as specified in Table 1.NOTE 1Fine grain steels are understood as steels with a ferritic grain size of 6 or finer when tested in accordance with EN ISO 643.The requirements and definitions of EN 10028-1:2017 also apply.NOTE 2Once this European Standard is published in the EU Official Journal (OJEU) under Directive 2014/68/EU, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 2014/68/EU is limited to technical data of materials in this European Standard (Part 1 and the other relevant part of the series) and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of Directive 2014/68/EU are satisfied, needs to be done.