EN 10080:2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Designation
   5.1 Bar, coil and de-coiled product
   5.2 Welded fabric
   5.3 Lattice girders
6 Steelmaking and manufacturing processes
7 Performance characteristics
   7.1 Weldability and chemical composition
   7.2 Mechanical properties
   7.3 Dimensions, mass and tolerances
   7.4 Bond strength and surface geometry
   7.5 Verification of performance characteristics
8 Evaluation of conformity
   8.1 Factory production control
   8.2 Initial type testing
   8.3 Continuous surveillance of factory
        production control and audit testing
   8.4 Evaluation, reporting and action
   8.5 Assessment of the long term quality level
9 Test methods
   9.1 Bars, coils and de-coiled products
   9.2 Welded fabric
   9.3 Lattice girders
10 Identification of the manufacturer and the
   technical class
   10.1 Bar
   10.2 Coil
   10.3 De-coiled product
   10.4 Welded fabric
   10.5 Lattice girders
11 Verification of mechanical properties in the case
   of dispute
Annex A (informative) Examples of weld points in
                       lattice girder joints
Annex B (normative) Test methods for lattice girders
Annex C (informative) Bond test for ribbed and indented
                       reinforcing steel - Beam test
Annex D (informative) Bond test for ribbed and indented
                       reinforcing steel - Pull-out test
Annex E (informative) Comparison of symbols used in this
                       European Standard with those used in
                       EN 1992-1-1 and EN 1992-1-2
Annex ZA (informative) Clauses of this European Standard
                       addressing the provisions of the EU
                       Construction Products Directive
Bibliography

This document specifies general requirements and definitions for the performance characteristics of weldable reinforcing steel used for the reinforcement of concrete structures, delivered as finished products in the form of:-bars, coils (rod, wire) and de-coiled products;-sheets of factory-made machine-welded fabric;-lattice girders.1.2Steels according to this document have a ribbed, indented or smooth surface.1.3This document does not apply to:-non-weldable reinforcing steel;-galvanized reinforcing steel;-epoxy-coated reinforcing steel;-corrosion resistant reinforcing steel;-prestressing steels (see prEN 10138-1 to -4);-indented strip;-further processing, e.g. cutting or cutting and bending.