EN 10089:2002

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification and designation
   4.1 Classification
   4.2 Designation
5 Information to be supplied by the purchaser
   5.1 Mandatory information
   5.2 Options
6 Manufacturing process
   6.1 General
   6.2 Deoxidation
   6.3 Heat-treatment and surface condition at delivery
7 Requirements
   7.1 Chemical composition, hardness and hardenability
   7.2 Shearability
   7.3 Structure
   7.4 Internal soundness
   7.5 Surface quality and decarburisation
   7.6 Dimensions, tolerances on dimensions and shape
8 Inspection and testing
   8.1 Types and contents of inspection documents
   8.2 Specific inspection and testing
9 Marking
Annex A (normative) Supplementary or special requirements
        A.1 Content of no-metallic inclusions
        A.2 Non-destructive testing
        A.3 Product analysis
        A.4 Special agreements for marking
Annex B (informative) Maximum dimensions for rounds and flats
        based on the 100% hardenability scatterband (see Table 7)
Annex C (informative) Dimensional standards applicable to
        products complying with this European Standard
Annex D (informative) Guidance values for the mechanical
        properties of quenched and tempered test pieces
        (maximum dimensions as given in Table 5)
Bibliography

1.1 This European Standard specifies the technical delivery requirements for round and flat bars and rod manufactured from the alloy steels listed in table 3, intended for hot-formed and subsequently heat-treated springs or cold-formed and subsequently heat-treated springs. The products are supplied in one of the heat-treatment conditions given for the different types of products in table 1, lines 2 to 6, and in one of the surface conditions given in table 2.