EN 10208-1:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Classification and designation
   5.1 Classification
   5.2 Designation
6 Information to be supplied by the purchaser
   6.1 Mandatory information
   6.2 Options
   6.3 Example of ordering
7 Manufacturing
   7.1 General
   7.2 Steelmaking
   7.3 Pipe manufacture
   7.4 Heat treatment condition
   7.5 Sizing
   7.6 Strip end welds
   7.7 Jointers
   7.8 General requirements for non-destructive
        testing
8 Requirements
   8.1 General
   8.2 Chemical composition
   8.3 Mechanical properties
   8.4 Weldability
   8.5 Appearance and soundness
   8.6 Dimensions, masses and tolerances
9 Inspection
   9.1 Types of inspection and inspection documents
   9.2 Summary of inspection and testing
   9.3 Selection and preparation of samples and test
        pieces
   9.4 Test methods
   9.5 Retests, sorting and reprocessing
10 Marking of the pipes
   10.1 General marking
   10.2 Special marking
11 Coating for temporary protection
Annex A (normative) - Specification of welded jointers
Annex B (normative) - Treatment of imperfections and
        defects disclosed by visual examination
Annex C (normative) - Non-destructive testing
Bibliography

This European Standard specifies the technical delivery conditions for seamless and welded steel pipes for the on land transport of combustible fluids primarily in gas supply systems but excluding pipeline applications in the petroleum and natural gas exploration and production industries. It includes less stringent quality and testing requirements than those in EN 10208-2.NOTE 1Steel pipes for pipeline transportation systems within the petroleum and natural gas exploration and production industries are covered by ISO 3183 [1]. This standard specifies products with the same (and additional) strength levels and partly similar (but not identical) requirements as EN 10208-1 and EN 10208-2 and is with two additional annexes specifying deviating or additional requirements also published as API Spec 5L [4].NOTE 2This European Standard does not apply to cast steel pipe.