EN 10244-2:2009

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Coating requirements
  4.1 Requirements for the coatings material
  4.2 Requirements relating to coating on the wire
      4.2.1 Coating mass
      4.2.2 Appearance of coating
      4.2.3 Dipping test
      4.2.4 Special finishes
      4.2.5 Adherence of coating
5 Test conditions
  5.1 Selection of samples
  5.2 Determination of mass of coating
      5.2.1 General
      5.2.2 Gravimetric method
      5.2.3 Gaseous volumetric method
  5.3 Dipping test
      5.3.1 Principle
      5.3.2 Reagents
      5.3.3 Preparation of test piece
      5.3.4 Performing of the test
      5.3.5 Interpretation of results
Bibliography

This part of this European Standard specifies the requirement for coating mass, other properties and testing of zinc and zinc alloy coatings on steel wire and steel wire products of circular or other section.