EN 10269:2013

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Dimensions and tolerances on dimensions
5 Calculation of mass
6 Classification and designation
7 Information to be supplied by the purchaser
8 Requirements
9 Inspection
10 Sampling
11 Test methods
12 Marking
Annex A (informative) - Reference data on some physical
        properties
Annex B (informative) - Guidance for heat treatment
Annex C (informative) - Reference data of strength values
        for 1% (plastic) creep strain and creep rupture
Annex D (informative) - Reference data for the relaxation
        properties
Annex E (informative) - Significant changes to the previous
        version EN 10269:1999
Annex ZA (informative) - Relationship between this
         European Standard and the Essential Requirements
         of EU Directive 97/23/EC
Bibliography

This European Standard specifies requirements for semi-finished products, bars and rods for fasteners with properties specified at elevated and/or low temperatures made of non-alloy and alloy (including stainless) steels and nickel alloys as given in Table 1.The requirements of this standard may be applied also to the finished fasteners.The general technical delivery conditions in EN 10021 also apply to products supplied in accordance with this European Standard.NOTEOnce this European Standard is published in the EU Official Journal (OJEU) under Directive 97/23/EC, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 97/23/EC is limited to technical data of materials in this European Standard and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of Directive 97/23/EC are satisfied, needs to be done.