EN 12101-3:2015

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions, symbols and abbreviations
4 Requirements
5 Testing, assessment and sampling methods
6 Assessment and verification of constancy of
  performance - AVCP
7 Marking, labelling and packaging
Annex A (normative) - Criteria to determine family of fans
        in order to select the sizes to be tested
Annex B (normative) - Criteria to determine a family of
        motors in order to select the sizes to be tested
Annex C (normative) - Test method for the determination
        of fire resistance of powered smoke and heat control
        ventilators (fans)
Annex D (normative) - Test methods for electric motors to
        determine the impact of the changes on the product
        characteristics
Annex E (normative) - Test method for assessing the
        response delay and ability to open under environmental
        conditions
Annex F (informative) - Explanatory notes
Annex G (informative) - General guidance for installation
        and maintenance
Annex ZA (informative) - Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Regulation
Bibliography

This European Standard specifies the products characteristics of powered smoke and heat control ventilators (fans) intended to be used as part of a powered smoke and heat control ventilation system in construction works. It provides test and assessment methods of the characteristics and the compliance criteria of the test assessment results.This European Standard applies to the following:a)fans for smoke and heat control ventilation;b)impulse/jet fans for smoke and heat control ventilation;