EN 1279-5:2005+A2:2010

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Evaluation of conformity
6 Marking and/or labelling
Annex A (normative) Rules for the use of 'other party
        ITT results'
Annex B (informative) Use of IGUs when subjected to UV
        and/or in SSG
Annex C (informative) Installation of the insulating
        glass units
Annex D (informative) Provisions for voluntary involvement
        of third party(ies)
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of EU Construction
         Products Directive
Bibliography

This European Standard specifies requirements, the evaluation of conformity and the factory production control of insulating glass units for use in buildings.NOTE 1For glass products with electrical wiring or connections for e.g. alarm or heating purposes, other directives, e.g. Low Voltage Directive, may apply.The main intended uses of the insulating glass units are installations in windows, doors, curtain walling, roofs and partitions where there exists protection against direct ultraviolet radiation at the edges.NOTE 2In cases where there is no protection against direct ultra-violet radiation at the edges, such as structural sealant glazing systems, additional European technical specifications should be followed (e.g. !EN 15434", !EN 13022-1").NOTE 3Units for which the intended use is only ‘artistic’ and therefore no essential requirement is required, are not subject to CE marking and are not part of this European Standard.