EN 130500:1998

Section 1 General
1.1 Scope
1.2 Normative references
1.3 Information to be given in a detailed specification
1.4 Definitions
1.5 Marking
Section 2 Preferred ratings and characteristics
2.1 Preferred climatic categories
2.2 Preferred values of ratings
Section 3 Quality assessment procedures
3.1 Primary stage of manufacture
3.2 Structurally similar components
3.3 Certified test records
3.4 Qualification approval
3.5 Quality conformity inspection
Section 4 Tests and measuring methods
4.1 Visual examination and check of dimensions
4.2 Electrical tests
4.3 Robustness of terminations
4.4 Resistance to soldering heat
4.5 Solderability
4.6 Rapid change of temperature
4.7 Vibration
4.8 Bump
4.9 Shock
4.10 Climatic sequence
4.11 Damp heat, steady state
4.12 Endurance
4.13 Charge and discharge
Annexes
A (normative) Test plan for qualification approval and
quality conformity inspection
B (normative) Test schedule for qualification approval

Defines requirements for fixed capacitors for direct current, having metallized electrodes and polycarbonate dielectric to be used in electronic equipment. May have self-healing properties dependent on conditions of use. Mainly intended for applications where the a.c. component is small respecting the rated voltage. Describes two performance grades of capacitors. Defines preferred ratings and characteristics, and chooses from EN 130000 the appropriate quality assessment methods, tests and measurement procedures, together with general performance requirements.