EN 133200:1999

Foreword
1. GENERAL
1.1 Scope
1.2 Related documents
1.3 Information to be given in a detail specification
1.4 Terminology
1.5 Marking
2. PREFERRED RATINGS AND CHARACTERISTICS
2.1 Preferred characteristics
2.2 Preferred values of ratings
3. QUALITY ASSESSMENT PROCEDURES
3.1 Primary stage of manufacture
3.2 Structurally similar filters
3.3 Certified records of released lots
3.4 Approval testing
3.5 Quality conformance inspection
4. TEST AND MEASUREMENT PROCEDURES
4.0 Capacitance and tan delta measurements
4.1 Visual examination and check of dimensions
4.2 Voltage proof
4.3 Insulation resistance
4.4 D.c. line resistance or voltage drop at rated current
4.5 Insertion loss
4.6 Resistance
4.7 Robustness of terminations
4.8 Resistance to soldering heat
4.9 Solderability
4.10 Rapid change of temperature
4.11 Vibration
4.12 Bump
4.13 Shock
4.14 Container sealing
4.15 Climatic sequence
4.16 Damp heat, steady state
4.17 Temperature rise
4.18 Impulse voltage
4.19 Endurance
4.20 Charge and discharge
4.21 Passive flammability
4.22 Current overload
4.23 Solvent resistance of the marking
4.24 Component solvent resistance
Annex A Test schedule for qualification approval
Annex B Test schedule for safety requirements only
Annex C Circuit for the impulse voltage test
Annex D Suitable circuit for the endurance test
Annex E Declaration of design (normative)

Defines passive filter units for electromagnetic interference suppression which fall within the scope of the Generic Specification EN 133000. Specified according to this specification will either be connected to mains supplies, when compliance with the mandatory tests of Table 2 is necessary, or used on other circuit positions where the equipment specification prescribes that some or all of these safety tests are required. Applies to those connected to an a.c. mains or other supply with a nominal voltage not exceeding 1000 V a.c. (r.m.s.) or 1000 V d.c. with a nominal frequency not exceeding 400 Hz.