EN 14154-1:2005+A2:2011

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Technical characteristics
5 Meter classification
6 Marking
7 Metrological characteristics
8 Meter performance requirements
9 Metrological control
Annex A (normative) - Checking facilities
Annex B (normative) - In-line meter dimensions
        (including alternative lengths)
Annex C (informative) - Table of rated operating,
        limiting and references conditions
Annex D (informative) - Test program
Annex ZA (informative) - Relationship between this
         European Standard and the Essential
         Requirements of EU Directive 22/2004/EC
         on Measuring Instruments
Bibliography

This document applies to water meters intended for residential, commercial, light industrial and industrial use, and specifies the requirements and certification procedures for water meters, irrespective of the design technologies used to meter the actual volume of clean cold potable water or heated water, flowing through a fully charged, closed conduit. These water meters shall incorporate devices, which indicate the integrated volume.This document also applies to water meters based on electrical or electronic principles, and to water meters based on mechanical principles incorporating electronic devices, used to meter the actual volume flow of cold potable water or heated water. It provides metrological requirements for electronic ancillary devices when they are subject to metrological control. As a rule the ancillary devices are optional. However national or international regulations make some ancillary devices mandatory in relation to the utilisation of the water meter.