EN 1870-19:2013

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
6 Information for use
Annex A (normative) - Stability test
Annex B (normative) - Test for rigidity of
        building site saws
Annex C (normative) - Saw spindle dimensional
        tolerances
Annex D (normative) - Riving knife mounting
        strength test
Annex E (normative) - Riving knife lateral
        stability test
Annex F (normative) - Minimum dimensions
        of the machine table, extension table
        and insert
Annex G (normative) - Saw blade guard
        stability test
Annex H (normative) - Impact test method
        for guards
Annex I (normative) - Braking tests
Annex ZA (informative) - Relationship between this
         European Standard and the Essential
         Requirements of EU Directive 2006/42/EC
Bibliography

This European Standard deals with all significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to stationary and displaceable circular saw benches (with or without sliding table and/or demountable power feed unit) and building site saws, hereinafter referred to as "machines", designed to cut solid wood, chipboard, fibreboard, plywood and also these materials, if they are covered with plastic edging and/or plastic/light alloy laminates, when they are used as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse.Machines which are designed to cut wood-based material may also be used for cutting hardened plastic materials with similar physical characteristics as wood.NOTE 1For the definition of stationary and displaceable machine see 3.2.9 and 3.2.10.NOTE 2Circular saw benches are used for ripping, cross cutting, dimensioning and grooving. Building site saws are used for ripping, cross cutting and dimensioning.The requirements of this document apply also to machines designed for grooving with a width not exceeding 20 mm in one pass by using a milling tool.This document does not apply to:a)machines set up on a bench or a table similar to a bench, which are intended to carry out work in a stationary position, capable of being lifted by one person by hand. The bench can also be an integrated part of the machine if it consists of hinged legs which can be extended down;b)hand held woodworking machines including any adaptation permitting their use in a different mode, i.e. bench mounting.NOTE 3Transportable motor-operated electric tools are covered by the requirements of EN 61029-1:2009 together with EN 61029-2-1:2012; a hand-held motor-operated electric tool and a saw bench to form an integrated whole are covered by EN 60745-1:2009 together with EN 60745-2-5: 2010.For the purpose of this document, building site saws having a tiltable spindle are considered to be circular saw benches.This document is not applicable to circular saw benches (with and without sliding table) and building site saws which are manufactured before the date of its publication as EN.NOTE 4Machines covered by this document are listed under 1.1 of Annex IV of the Machinery Directive.