EN 1978:1998

Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
    3.1 cathode
    3.2 lot (copper cathodes)
    3.3 bundle
    3.4 sample cathodes
    3.5 Cathode sample
    3.6 bulk sample
    3.7 analysis sample
4 Designations
    4.1 Material
    4.2 Product
5 Ordering information
6 Requirements
    6.1 Composition
    6.2 Electrical properties
    6.3 Dimensions and tolerances
    6.4 Surface condition
7 Sampling
8 Test methods
    8.1 Analysis
    8.2 Electrical resistivity
    8.3 Retests
    8.4 Rounding of results
9 Declaration of conformity and inspection of documentation
    9.1 Declaration of conformity
    9.2 Inspection documentation
10 Marking
Annex A (normative) Methods for use in cases of dispute, for
the sampling of cathodes and for the preparation of analysis
samples
Annex B (informative) Information on electrical resistivity
and conductivity relationships
Annex C (informative) Bibliography

This standard specifies the composition and property requirements for cathodes of two copper grades, designated Cu-CATH-1 (CR001A) and Cu-CATH-2 (CR002A). Annex A (normative) describes methods for sampling cathodes for use in cases of dispute between the purchaser and the supplier. Annex B (informative) gives information on the relationships between electrical resistivity and conductivity of copper.