EN 230:2005

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Normal conditions for testing and measurement tolerances
6 Constructional requirements
7 Functional requirements
8 Protection against environmental influences
9 Protection against internal faults
10 Additional requirements for complex electronics
11 Marking, installation and operating instructions
Annex A (normative) Electrical/electronic component fault
        modes tables
Annex B (informative) Functional characteristics of burner
        control systems, to be given by the appliance standard
Annex C (normative) Requirements for DC supplied burner controls
Annex D (informative) Functional diagrams of oil burner controls
Bibliography

This document specifies the requirements, operating conditions and test methods for burner control systems for automatic and semi-automatic oil burners with or without fans.It also applies to dual fuel burners, for use with either oil or gaseous fuels, when operating on oil.This document covers type testing only.This document also applies to automatic burner control systems, programming units or flame detector devices that include additional functions.Automatic burner control systems utilising thermo-electric flame supervision devices are not covered by this document.