EN 60034-19:2014

FOREWORD
1 Scope
2 Normative references
3 Terms, definitions, symbols and subscripts
4 Determination of current and voltage specific
   quantities (rectifier-fed)
5 Determination of the armature circuit inductance
6 Determination of shunt-field inductance
7 Determination of black-band zone
8 Determination of the maximum permissible rate
   of change of armature current
9 Additional losses and efficiency of rectifier-fed
   d.c. motors
10 Determination of speed regulation
11 Determination of the shunt regulation curve
12 Determination of the magnetisation curve
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

IEC 60034-19:2014 applies to d.c. machines rated 1 kW and above operating on rectifier-fed power supplies, d.c. buses or other d.c. sources and provides standardized methods intended to determine characteristic quantities for conventional and rectifier-fed d.c. machines. These methods supplement the requirements in IEC 60034-1 and IEC 60034-2-1. The main changes with regard to the previous edition are as follows:- description of the procedure for black band testing has been detailed and clarified;- procedures for measurement of the magnetization curves under no-load and load conditions have been added.