EN 60317-0-1:2014

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, general notes and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation (nominal conductor diameters
   up to and including 1,600 mm)
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) - Dimensions for intermediate nominal
        conductor diameters (R 40)
Annex B (informative) - Method for the calculation of linear
        resistance
Annex C (informative) - Resistance
Bibliography
Annex ZA (normative) - Normative references to international
         Publications with their corresponding
         European publications

IEC 60317-0-1:2013 specifies general requirements of enamelled round copper winding wires with or without bonding layer. The range of nominal conductor diameters is given in the relevant specification sheet. This fourth edition cancels and replaces the third edition published in 2008. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: - revision to the definition of nominal conductor dimension; - new subclause containing general notes on winding wire, formerly a part of the scope; - revision to elongation requirements in Table 4; - revisions to Clause 13, Breakdown voltage, to include new requirements for intermediate wire diameters; - revision to continuity of insulation requirements in Table 13; - revision to the introduction of Annex A; - revision to B.2 of Annex B; - revision to Table C.1 of Annex C. Keywords: requirements of enamelled round copper winding wires