EN 60601-2-65:2013

FOREWORD
INTRODUCTION
201.1 Scope, object and related standards
201.2 Normative references
201.3 Terms and definitions
201.4 General requirements
201.5 General requirements for testing of ME
       EQUIPMENT
201.6 Classification of ME EQUIPMENT and
       ME SYSTEMS
201.7 ME EQUIPMENT identification, marking
       and documents
201.8 Protection against electrical HAZARDS
       from ME EQUIPMENT
201.9 Protection against MECHANICAL HAZARDS
       of ME EQUIPMENT and ME SYSTEMS
201.10 Protection against unwanted and excessive
       radiation HAZARDS
201.11 Protection against excessive temperatures
       and other HAZARDS
201.12 Accuracy of controls and instruments and
       protection against hazardous outputs
201.13 HAZARDOUS SITUATIONS and fault
       conditions
201.14 PROGRAMMABLE ELECTRICAL
       MEDICAL SYSTEMS (PEMS)
201.15 Construction of ME EQUIPMENT
201.16 ME SYSTEMS
201.17 Electromagnetic compatibility of ME
       EQUIPMENT and ME SYSTEMS
202 Electromagnetic compatibility - Requirements
       and tests
203 Radiation protection in diagnostic X-ray
       equipment
Annexes
Annex C (informative) - Guide to marking and
        labeling requirements for ME EQUIPMENT
        and ME SYSTEMS
Annex AA (informative) - Particular guidance and
         rationale
Annex BB (informative) - Identification of parts of
         dental X-RAY INTRA-ORAL SYSTEMS in
         relation to defined terms in this standard
Bibliography
Index of defined terms used in this particular standard
Annex ZA (normative) - Normative references to
         international publications with their corresponding
         European publications

IEC 60601-2-65:2012 applies to the basic safety and essential performance of dental intra-oral X-ray equipment and its main components. The scope of this standard is restricted to X-ray equipment where the X-ray tube assembly contains the high-voltage transformer assembly. Dental extra-oral X-ray equipment is excluded from the scope of this standard. This particular standard has been prepared to provide, based on IEC 60601-1:2005 and its collaterals, a complete set of basic safety and essential performance requirements for dental intra-oral X-ray equipment. While the previously existing standards for such equipment were dedicated to components and subsystems, this particular standard addresses the system level of dental intra-oral X-ray equipment. Components and their functions are addressed as far as necessary.