EN 60664-5:2007

FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Terms and definitions
4 Fundamentals of clearance and creepage distance
  dimensioning
  4.1 Introductory remark
  4.2 Basic principles
  4.3 Voltages and voltage ratings
  4.4 Frequency
  4.5 Time under voltage stress
  4.6 Pollution
  4.7 Information supplied with the equipment
  4.8 Insulating material
5 Requirements and dimensioning procedures
  5.1 General
  5.2 Dimensioning of clearances
  5.3 Dimensioning of creepage distances
  5.4 Requirements for design of solid insulation
6 Tests and measurements
  6.1 Tests
  6.2 Measurement of creepage distances and clearances
Annex A (informative) - Dimensioning to maintain minimum
                        insulation resistance
Annex B (normative) - Water adsorption test
Annex C (informative) - Dimensioning diagrams
Annex D (informative) - Withstand voltage test for creepage
                        distance under humid conditions
Annex ZA (normative) - Normative references to international
                       publications with their corresponding
                       European publications
Bibliography

Specifies the dimensioning of clearances and creepage distances for spacings equal to or less than 2 mm for printed wiring board and equivalent constructions, where the clearance and the creepage distance are identical and are along the surface of solid insulation, such as the paths described in example 1, example 5 and example 11 of 4.2 of Part 1. The dimensioning is more precise than that provided by Part 1 (i.e EN 60664-1). This standard can only be used as an entirety. It is not permitted to select one or more clauses from this standard and to use them in place of the corresponding clauses of Part 1. When this standard is applied to the dimensioning of clearances and creepage distances, all clauses shall be used in place of the corresponding clauses given in Part 1. For clearances and creepage distances larger than 2 mm and for solid insulation in general, Part 1 applies. This standard is based on the following criteria for dimensioning: - minimum clearances independent of the micro-environment (see Table 2); - minimum creepage distances for pollution degrees 1, 2 and 3 to avoid failure due to tracking (see Table 4); - minimum creepage distances to avoid flashover across the insulating surface (see Table 5). A test method is specified for allocating unclassified insulating material to the relevant water adsorption group. Has the status of a basic safety publication in accordance with IEC Guide 104.