EN 60695-11-3:2012

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Method A - Production of a standardized 500 W
  nominal test flame based on existing hardware
5 Method C - Production of a standardized 500 W
  nominal test flame based on nonadjustable hardware
6 Classification and designation
Annex A (normative) - Test arrangements - Method A
Annex B (normative) - Test arrangement - Method C
Annex C (informative) - Recommended arrangements
        for the use of either of the test flames
Annex D (informative) - Test arrangements for tests on
        equipment
Annex E (informative) - Test arrangements for tests on
        material
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

IEC 60695-11-3:2012 provides detailed requirements for the production of either of two 500 W nominal, pre-mixed type test flames. The approximate overall height of each flame is 125 mm. Two methods of producing a test flame are described: - Method A uses methane. - Method C can use either methane or propane. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. This first edition of IEC 60695-11-3 cancels and replaces the second edition of IEC/TS 60695-11-3 published in 2004. It constitutes a technical revision and now has the status of an International Standard. The main changes with respect to the second edition of IEC/TS 60695-11-3 are the integration of minor editorial and technical changes throughout the text. It has the status of a basic safety publication in accordance with IEC Guide 104 and ISO/IEC Guide 51. Keywords: Fire hazard, Test flames, 500 W flames