EN 61076-7:2000

Clause
1 General
   1.1 Scope
   1.2 Normative references
2 Technical
   2.1 Terminology
   2.2 Classification into climatic categories
   2.3 Material
   2.4 Finish
   2.5 Styles
   2.6 IEC type designation
   2.7 Marking
   2.8 Installation instructions and tools
   2.9 Delivery conditions
3 Quality assessment procedures
   3.1 Primary stage of manufacture
   3.2 Structurally similar components
   3.3 System of levels
   3.4 Grouping of tests
   3.5 Approval of manufactureres, independent test
        laboratories and distributors
   3.6 Qualification approval
   3.7 Test records
   3.8 Quality conformance inspection
4 General requirements and test schedules
   4.1 General
   4.2 Test procedures and measuring methods
   4.3 Preconditioning
   4.4 Preparation of specimens
   4.5 Test schedule
5 Capability approval procedure
   5.1 General
   5.2 Manufacturing approval
   5.3 Capability manual
   5.4 Specifications
   5.5 Maintenance of capability
   5.6 Changes to the capability approval
   5.7 Test schedule
Annex A (normative) Proposal for mechanical endurance
        test method
Annex B (normative) Proposal for lock-wire hole
        strength test method
Annex C (normative) Proposal for housing (shell)
        continuity test method
Annex D (normative) Proposal for mating and unmating
        test method
Annex E (normative) Proposal for accessory thread
        strength test method
Annex ZA (normative) Normative references to
        international publications with their
        corresponding European publications
Bibliography

Establishes uniform specifications, type test requirements and quality assessment procedures for cable outlet accessories as well as rules for the preparation of detail specifications for cable outlet accessories of assessed quality for connectors for frequencies below 3 MHz.