EN 61212-2:2006

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Conditioning of specimens
4 Dimensions
  4.1 General
  4.2 External diameter
  4.3 Internal diameter
  4.4 Wall thickness
  4.5 Departure from straightness - Applicable
      to all tubes up to 300 mm diameter
5 Mechanical tests
  5.1 Flexural strength perpendicular to laminations
  5.2 Axial compressive strength
  5.3 Cohesion between layers
6 Electrical tests
  6.1 Electric strength and breakdown voltage
  6.2 Insulation resistance after immersion in water
  6.3 Dissipation factor and permittivity (tube only)
7 Other tests
  7.1 Thermal endurance
  7.2 Water absorption
  7.3 Density
  7.4 Flammability
Annex ZA (normative) Normative references to
         international publications with their
         corresponding European publications
BIBLIOGRAPHY

This part of IEC 61212 describes methods of test for the materials defined in IEC 61212-1. Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.