EN 61300-1:2016

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Requirements for the IEC 61300-2 series and
   the IEC 61300-3 series
5 Standard atmospheric conditions
6 Significance of the numerical value of a quantity
7 Graphical symbols and terminology
8 Safety
9 Calibration
10 Launch conditions
Annex A (normative) - Multimode launch condition
        requirement for measuring attenuation of
        components terminated on IEC 60793-2-10 type
        A1a and A1b fibres
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

IEC 61300-1:2016 provides general information and guidance for the basic test and measurement procedures defined in the IEC 61300-2 and IEC 61300-3 series for interconnecting devices and passive components. This standard should be used in combination with the relevant specification which will define the tests to be used, the required degree of severity for each of them, their sequence, if relevant, and the permissible performance limits. In the event of conflict between this basic standard and the relevant specification, the latter will take precedence. This fourth edition cancels and replaces the third edition published in 2011. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: reconsideration of the terms and definitions; addition of Clause 4.Keywords: test and measurement procedures for interconnecting devices and passive components