EN 61347-2-4:2001/corrigendum:2010
Superseded
LAMP CONTROLGEAR - PART 2-4: PARTICULAR REQUIREMENTS FOR D.C. SUPPLIED ELECTRONIC BALLASTS FOR GENERAL LIGHTING
01-12-2013
07-01-2011
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
7.1 Mandatory markings
7.2 Information to be provided, if applicable
8 Protection against accidental contact with live
parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Pulse voltages
15 Abnormal conditions
15.1 Removal of lamp(s)
15.2 Lamp fails to start (cathodes intact
electrically)
15.3 Polarity reversal
16 Fault conditions
17 Construction
18 Creepage distances and clearances
19 Screws, current-carrying parts and connections
20 Resistance to heat, fire and tracking
21 Resistance to corrosion
Annex A (normative) Test to establish whether a
conductive part is a live part, which may
cause an electric shock
Annex B (normative) Particular requirements for
thermally protected lamp controlgear
Annex C (normative) Particular requirements for
electronic lamp controlgear with means of
protection against overheating
Annex D (normative) Requirements for carrying out the
heating tests of thermally protected lamp
controlgear
Annex E (normative) Use of constant S other than 4500
in t[w] tests
Annex F (normative) Draught-proof enclosure
Annex G (normative) Explanation of the derivation of
the values of pulse voltages
Annex H (normative) Tests
Annex ZA (normative) Normative references to
international publications with their
corresponding European publications
Table 1 - Pulse voltages
Specifies particular safety requirements for d.c. supplied electronic ballasts intended for operation from transient and surge-free power sources, operated directly from batteries without charging equipment as used in leisure equipment.
| Committee |
TC 34
|
| DevelopmentNote |
To be used in conjunction with EN 61347-1 (10/2003) Together with EN 61347-1 and parts 2-1, 2-2, 2-3, 2-5, 2-6, 2-7, 2-8 and 2-9 of EN 61347 supersedes EN 60920, EN 60922, EN 60924, EN 60926, EN 60928 and EN 61046. (07/2005)
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Superseded
|
| Supersedes |
| Standards | Relationship |
| IEC 61347-2-4:2000 | Identical |
| NBN EN 61347 2-4 : 2001 | Identical |
| NEN EN IEC 61347-2-4 : 2001 | Identical |
| I.S. EN 61347-2-4:2001 | Identical |
| PN EN 61347-2-4 : 2007 AC 2011 | Identical |
| VDE 0712-34 : 2001 COR 2 2011 | Identical |
| BS EN 61347-2-4:2001 | Identical |
| CEI EN 61347-2-4 : 2001 | Identical |
| NF EN 61347-2-4 : 2001 | Identical |
| UNE-EN 61347-2-4:2002 | Identical |