EN 62099:2001

Introduction
1 General
   1.1 Scope
   1.2 Normative references
   1.3 Definitions
2 Requirements
   2.1 Classification
        2.1.1 Type
        2.1.2 Style
        2.1.3 Variant
        2.1.4 Interface standard
        2.1.5 Environmental category
        2.1.6 Assessment level
        2.1.7 Normative reference extension
   2.2 Documentation
        2.2.1 Symbols
        2.2.2 Specification system
        2.2.3 Drawings
        2.2.4 Tests and measurements
        2.2.5 Test reports
        2.2.6 Instructions for use
   2.3 Standardization system
        2.3.1 Interface standards
        2.3.2 Performance standards
        2.3.3 Reliability standards
        2.3.4 Interlinking
   2.4 Design and construction
        2.4.1 Materials
        2.4.2 Workmanship
   2.5 Quality
   2.6 Performance
   2.7 Identification and marking
        2.7.1 Variant identification number
        2.7.2 Component
        2.7.3 Package marking
   2.8 Packaging
   2.9 Storage conditions
   2.10 Safety
3 Quality assessment procedures
   3.1 Primary stage of manufacture
   3.2 Structurally similar components
   3.3 Qualification approval procedures
        3.3.1 Fixed sample procedure
        3.3.2 Lot-by-lot and periodic procedures
        3.3.3 Qualifying specimen
        3.3.4 Sample size
        3.3.5 Preparation of specimens
        3.3.6 Qualification testing
        3.3.7 Qualification failures
        3.3.8 Maintenance of qualification approval
        3.3.9 Qualification report
   3.4 Quality conformance inspection
        3.4.1 Lot-by-lot inspection
        3.4.2 Periodic inspection
   3.5 Certified records of released lots
   3.6 Delayed deliveries
   3.7 Delivery release before completion of group B tests
   3.8 Alternative test methods
   3.9 Unchecked parameters
Bibliography
Annex ZA Normative references to international publications
         with their corresponding European publications

Applies to fibre optic wavelength switches, which are: - passive optical devices, without optical amplification or opto-electronic conversion - restricted to the routing of light rather than intentional power division - have two or more ports with optical fibres or connectors. The standard establishes switch requirements and quality assessment procedures.